MMC-Reader 2.0.3.15

Evaluation	4.00/5 votes - 5
License	Shareware
Restriction	the number of diagnostic parameters is limited, reading and erasing error codes is disabled
Version	2.0.3.15
Updated	15.10.2015
OS	Windows 8.1, 8, 7, Vista, XP
Interface	English
Разработчик	mmc-reader.ru
Category	Auto
Downloads (today/total)	0 / 3 673
Size	4.39 MB

Download

MMC-Reader is a program for diagnosing Mitsubishi cars using the K-Line data bus. It is used to check the connection with the car via MMC K-Line + SCI, or any K-Line adapter, provided that the connection start is manually activated via 1 pin of the diagnostic connector.

The principle of operation of the MMC-Reader diagnostic scanner is based on the recognition of the control unit identifier, according to which a set of parameters and tests relevant to this code is selected, which distinguishes it from similar programs of the lower price range.

Connection to the car is possible through the following types of adapters:

MMC SCI K-Line
J2534 (Openport 2.0)
Third-party K-Line adapter

Features of MMC-Reader:

The entire list of known identifiers is available
Scalable font when displaying readings
Full-screen mode for displaying graphs with the ability to save the results.
Printing reports
Reading and resetting error codes
Running tests

Features of the MMC-Reader if there is a 16 pin diagnostic connector on the car. or 12 pin.:

Identification of control units
MPI/GDI/Disel - reading and erasing codes, viewing current data, managing IT, resetting adaptations
ISO engine - reading parameters, reading attrition of fault codes preliminary(Pending) and final (Mature)
AT/CVT/A-MT - Reading and erasing codes, viewing stored parameters(Freeze Frame) at the time of a malfunction on some variator transmissions, viewing current data, control IM, reset adaptations
ABS - Reading/erasing codes, viewing current data, managing IT
SRS - Reading/erasing codes, viewing current data
ECS - Reading/erasing codes, viewing current data, managing IM
AYC / ACD - Reading/erasing codes, viewing current data, managing IT
IMMOBILIZER - Reading/erasing codes, viewing current data, programming keys
TCL /STABILITY - Reading/erasing codes, viewing current data, managing IT
4WS - Reading/erasing codes, viewing current data, managing IT
SS4II - Reading/erasing codes, viewing current data, managing IT
HBB - Reading/erasing codes

The low-speed MMC SCI protocol, the factory advanced data exchange protocol MUT, the exchange protocol according to the ISO-9141-2 specification are supported.